Detailed Information on Renting High-Efficiency Vacuum Oil Filter
Renting High-Efficiency Vacuum Oil Filter At this time, pay attention to the response of each instrument. If the pressure gauge reading is greater than 0.3MPa, it indicates that the filter paper in the filter has absorbed more impurities and needs to be replaced with new filter paper. After the work is completed, refer to the working principle schematic diagram, open the air release valve to make the vacuum reach normal atmospheric pressure, drain the oil in the cylinder, and discharge the remaining oil from the oil drain plug to prevent mixing with different types of oil during next use. In winter, special attention should be paid to draining the water in the vacuum pump and water tank, otherwise the vacuum pump and water storage tank may freeze and be damaged.
When the vacuum surface reaches the limit, you can open the oil inlet valve until the oil level is visible in the lower sight glass of the vacuum cylinder, then start the oil discharge pump switch to begin normal circulation of oil filtration to remove impurities. Turn on the heater switch to evaporate moisture in the oil.
If there is a lot of moisture in the oil, the oil mist in the vacuum cylinder will increase. At this time, you must open the air release valve to control the appropriate vacuum degree. After the moisture decreases and the oil float drops, close the air release valve to make the vacuum reach the limit.
Renting High-Efficiency Vacuum Oil Filter
Usage and Features:
1. Vacuum oil filter, suitable for large power transmission and transformation equipment above 110KV and national main transformer power grids.
2. High vacuum degree, ultimate vacuum ≤5Pa, working vacuum ≤35Pa, large pumping speed, pumping rate ≥330L/S.
3. Combines three-dimensional flash evaporation and planar flash evaporation to make dehydration and degassing more thorough.
4. Adopts a control method combining solenoid valves.
5. Vacuum oil filling and vacuum drying of transformers.
6. This machine can perform live oil filtration for more than 300 hours.
7. Can meet the requirements for vacuuming and vacuum oil filling of transformer bodies during installation or maintenance on site.
8. Introduces Japanese low-temperature oil technology, which can effectively remove micro-water in oil and improve the withstand voltage value.
